DANOBAT SCP 500 D-I Operational Data Logging interface


 


The DANOBAT SCP 500 D-I Operational Data Logging interface for Band Sawing Machines Horizontal enables you to view conditions of production ressources, ascertain the plant utilization and analyze groupwork of the plant floor.

The Factory Data Collection technology integrates resources like Fine Blanking Presses, Long Bed Machining Centers or Horizontal turning and machining centers seamlessly with ERP/MES like Baan or infor and delivers consistent information (Takt Time, Fully Productive Time, Quality) in real time. With the MES Connector module you can:

  • Acquire manufacturer (MACBEE, BUDERUS, LIEBER...) and control-specific (FANUC MG, PHILIPS 6600, HURCO Ultimax BMC 30...) signals and operator input.

  • Combine input (DMP configuring, Extended T address or NC start disable) to uniform machine states like Power Off , End of Travel , DCON Communication Lost.

  • Transform states like (Power Off , End of Travel , DCON Communication Lost) to indicators (Takt Time, Fully Productive Time, Quality).

  • Analyze results in ERP/MES.

As the Manufacturing Execution System interface does not interfere with manufacturer-specific (MACBEE, BUDERUS, LIEBER) machine programming the Machine EDP Connector can be implemented rapidly.

By using Hardware independent, pre-built connectors for Bending machines, Sawing and filing machines or Presses hydraulic that are customized for controls (FANUC MG, PHILIPS 6600, HURCO Ultimax BMC 30...) you profit for Band Sawing Machines Horizontal from low total costs of ownership.

 

Additional Information

Datasheet DANOBAT SCP 500 D-I Operational Data Logging interface (PDF)

DNC Client

 

 

© 2010 • inventcom

Read more: danobat-scp-500-d-i-operational-data-logging-interface