SCULFORT MAXICAP 315 MES interface


 


The SCULFORT MAXICAP 315 MES interface for Centre lathes enables you to optimize your processes, capture process information and determine and analyze key figures of the plant floor.

The MDA connector integrates resources like Wire drawing machines, Section Benders Horizontal or Other Knuckle Joint Presses seamlessly with ERP/MES like Oracle or IBM and delivers consistent information (Fully Productive Time, Quality Loss, Changeover Time) in real time. With the SCADA - OPC - ERP connector you can:

  • Acquire manufacturer (CIBLAT FOUBERT, TAKAMATSU, VARNAMO...) and control-specific (ACRAMATIC 850 SX, Siemens Sinumerik 810, EMCO-TURN...) signals and operator input.

  • Combine input (Deceleration reference point approach, Last information or G96, constant cutting speed) to uniform machine states like Specific Alarm, In Cycle, Undefined .

  • Transform states like (Specific Alarm, In Cycle, Undefined ) to indicators (Fully Productive Time, Quality Loss, Changeover Time).

  • Analyze results in ERP/MES.

As the Manufacturing Execution System connector does not interfere with manufacturer-specific (CIBLAT FOUBERT, TAKAMATSU, VARNAMO) machine programming the Operational Data Logging interface can be implemented rapidly.

By using Hardware independent, pre-built connectors for Borers, Machining centers or Surface treatment machines that are customized for controls (ACRAMATIC 850 SX, Siemens Sinumerik 810, EMCO-TURN...) you profit for Centre lathes from low total costs of ownership.

 

Additional Information

Datasheet SCULFORT MAXICAP 315 MES interface (PDF)

DNC Client

 

 

© 2010 • inventcom

Read more: sculfort-maxicap-315-mes-interface